The Leifheit Centering Ground Peg

Leifheit Centering Ground PegThe Leifheit Centering Ground Peg is a cement-free ground peg for almost any rotary dryer. For households looking for even more stability than the Screw-In Ground Peg, the Centering Ground Peg is bigger, more protected, and easier to get in straight. Its construction starts with a metal core surrounded by sturdy plastic with a screw on the bottom and a rain cap on top. It fits a 50 millimeter dryer pole and has a lawn mowing edge to protect both the ground peg and your lawn mower.

To install the Leifheit Centering Ground Peg, first snap the lawn mowing edge together. Slide it onto the ground peg from the bottom. Now jam and twist the ground peg into the ground; you may prefer to start by digging a small hole with a garden spade. Insert the metal handle through both holes in the peg and twist it further into the ground with both arms. You may remove the peg in the same way, any time you wish to move it. Now just open the rain cap and insert your rotary dryer.

This ground peg’s top is removable and comes with three settings that you may adjust by sliding the notch around to each:

At Setting 1, you may remove the top.
At Setting 2, the top remains on the peg but spins.
At Setting 3, the top is completely secure.

Watch Brianna demonstrate the Leifheit Centering Ground Peg in the video below:

Posted by April 08, 2015 at 3:50 PM under Clotheslines and Laundry

Leave a Reply

Your email address will not be published.